ATTACK SQ-1, Installation Instructions Manual, Page: 4 / 12

www.MyTrickRC.com 4
FEATURES & FUNCTIONS
POWER CONNECTIONS & SETTINGS
LEDs LEGEND
USE THIS DIAGRAM TO
ASSIST IN THE LAYOUT
OF YOUR LIGHTING AND
FOR ANY NOTES.
MODE LED
When power is applied to the SQ-1, the
Power LED will
blink
. The number of LED blinks indicates the mode that
the controller is set to. If you’re in MODE 1 the LED will blink
one time then stay on steady. In MODE 2, the LED will blink
twice, MODE 3, three times, and so on.
MODE Button
To change the MODE, simply press the MODE Button.
NOTES:
• If there is no Power LED, then the controller may be set
to MODE 0 ALL OFF and you should switch to a different
mode.
• When SQ-1’s power is restarted, it will remember the
MODE it was last set to.
• If you plug the SQ-1’s power cable backwards into the
receiver or 9V Battery, no damage will occur but the
controller won’t behave correctly. To fix, just plug in
correctly.
• You can splice (cut and solder) up to four LEDs into one
SQ-1 output port. Splicing does void the warranty of the
LEDs, but this feature offers more options for your RC
vehicle.
• If you wish to do this then follow these simple guidelines:
• Solder all LEDs in parallel.
• All LEDs in the cable must be the same color.
• Don’t splice more than four LEDs into a single port.
POWER & MODE
LED
MODE
BUTTON