ATTACK OT80, Manual

Page: 38 / 48

38
6. MENU
1. With Manual program active , the new value
will be saved as permanent Set.
• If, after step 2., knob is pressed, it will be possible to
define, turning it, the Set interval (
Party : from
15min to 7days ), after which the previous setting
will be restored.
Attention: If program is in Standby, you cannot adjust the
Set temperature.
5.2 HEATING SET (Winter)
When room probe is disabled, instead of the Room Home,
the Heating Home appears and:
• Without external probe, or OTC curves modulation
disabled, the quick set allows you to change the
maximum Delivery.
• With external probe, and with OTC curves
modulation enabled, you can quickly change the
Delivery Offset.
Procedure:
As Room Set, Temporary Manual and Party functions
excluded.
5.3 HOT WATER SET (Summer and Winter)
From
Hot Water
Home, turn knob to enter the modification
of Set temperature. The same as Room Set, Temporary
Manual and Party functions excluded.
From Home, whether Room or Hot Water , pressing
the left button it is possible to enter to Menu (see also
INTERFACE section, paragraph SURFING MENU )
Warning: This section follows the same Menu outline.
Each paragraph corresponds to one Menu and each
subparagraph to one Submenu.
6.1 INFORMATION
Some parameters and values of Hot Water, Heating and
General are available only for check (some information
could not be accessible because they depend on UC).
6.1.1 HOT WATER
• OUTLET TEMPERATURE
Outlet probe temperature (current temperature
measured by Hot Water’s probe).
• FLOW
Flow rate (flow rate measured at the exit of Hot
Water – for instantaneous boiler).
6.1.2 HEATING
• CH SET
Current Delivery Set temperature for Heating,
corresponding to the wanted delivery
temperature, it is set up directly by user