Chapter 3: Monochrome Terminals
Initial Setup
MANU-MAXIMUS-02
Maximus Reference Manual
3-11
Revision-02
9.
Next the terminal displays the
Terminal Name
parameter that enables you to
set a unique up-to-20 character administrative name for the terminal. The
default name is “ATS” plus the last 6-digits of the terminal MAC address (e.g.,
ATS000001
).
Press the
enter
key to accept the displayed name or press the
clear
key then
use the numeric keys and the
F2
to change the name. The F2 key toggles the
active character (most recently typed) as listed in
The
F1
key repeats the previous character and the
clear
key deletes the active
(most recently typed) character.
When you are finished, press the
enter
key to save the new name and continue.
Terminal Name:
ATS000001
Applications such as Accu-Engine require “ATS” as the first three characters of the Terminal
Name. If not, Accu-Engine will only display the terminal IP address (that can change with
DHCP enabled).
Firmware Versions prior to 2.05.11(X) do not save any changes to the Terminal Name. If you
make any changes the terminal reverts to the default Terminal Name after a re-boot.
NOTE:
NOTE:
Table 3-2
Terminal Name Key to Character Mapping
Numeric Terminal Key
Toggling Characters (F2 Key)
0
0 (zero), Period (.), Space (
-
), Hyphen (-)
F1
A, B, C
F2
2, D, E, F
3
3, G, H, I
4
4, J, K, L
5
5, M, N, O
6
6, P, Q, R
7
7, S, T, U
8
8, V, W, X
9
9, Y, Z, Comma (,)
