ATS Maximus MCJ2000 Series, Reference Manual

Page: 139 / 214

Chapter 4: Color Terminals Setup Mode
MANU-MAXIMUS-02 Maximus Reference Manual 4-23
Revision-02
• You can change the host server without needing to set up your terminals.
• Since any host on the network can try to make a connection with the
terminal, any host that knows how to communicate with the terminal can
read data from the terminal.
4. The terminal displays the current Socket Port setting in the center of the screen.
The default value is
2500 . To change the displayed value:
• Press the “F5” key to select Socket Port and display the Enter the Socket
Port prompt screen.
• Use the numeric keys to type the new socket port number, up to five digits
(You can press the “
clear ” key to delete a number) then press the enter
key to apply the socket port change. The terminal returns to the TCP/IP
Setup screen and displays the new value for the
Socket Port field in the
center of the screen.
If you type an invalid socket port number the terminal displays
Invalid
Socket Port and returns you to the saved/default value.
5. Append EOT Yes adds an end-of-transmission (EOT) character to the end of
the communication packet. The default value is Append EOT No . Turning this
option on helps to eliminate the possibility of large packets being lost. There are
some networks that limit the size of a packet that can be transmitted between
devices. The
Append EOT No selection does not add (append) EOT numbers.
To change the displayed Append EOT value, press the “F6” key to select
between
Append EOT No and Append EOT Yes .
6. To change between Dynamic DHCP and Static IP modes press the “F2” key. If
you selected Dynamic DHCP , proceed to "Dynamic Mode Settings" on page 4-
25 . If you selected Static IP proceed to "Static Mode Settings" on page 4-26 .
7. You can use the “F7” key to select between PPP Disabled and PPP Enabled .
WiFi must be disabled before you can enable PPP.
Use
PPP Enabled to set up a GSM/GPRS terminal PPP communication for
connectivity with a host server over a cellular wireless data network.
To set up for GSM/GPRS support, you need a GSM/GPRS-modem-equipped
terminal and a data plan from a wireless carrier.
When you set this parameter to
PPP Enabled , the GSM PPP Setup screen
appears as shown in Figure 2 on page 4-24 with the current settings displayed
in the center of the screen.
To change the GSM / GPRS provider press the “F2” key to cycle through the
provider options. The available providers are;
stream , proximus , o2 , etisalat ,
datalink , att-gold , att , ats-tm , O2UK , ATS-t-mobil , Wlogic-ATT , wlogic ,
AIS , vodafoneUK , vodafone , vodacom , vodaPAYG , telenor , t-mobil-uk , t-
mobile .
Set “ Append EOT” to No unless your communication software or networking software
specifically support EOT (End Of Transmission).
If you set this to
Append EOT Yes and EOT is unsupported, the terminal could behave
unpredictably, including not responding to input.
CAUTION