ATS 2140-M Series, Instruction Manual

Page: 15 / 115

15
3.3 Unpacking Equipment
Carefully unpack the equipment and inspect it for damage during shipment. Retain all cartons and
packaging materials until the unit is operated and found to be in good condition. If damage has occurred
during shipping, notify the carrier and ATS immediately. If it is necessary to file a damage claim, retain
the packing materials for inspection by the carrier.
Unpacking and Setup
1. Carefully remove the shipping crate and packing materials. Do not discard the packing
materials until all items on the invoice have been accounted for.
2. Use an overhead crane or forklift to remove the test frame and control console from the pallet
and position it in the desired location.
NOTE: Use moving blankets between unit components, and follow accepted moving practices to avoid
damage to the tester.
NOTE: Position the test frame and console to allow ample room for maintenance.
3. If casters are supplied with the unit, install them in the cabinet base when it is lifted off the pallet.
4. Adjust the isolator mounts on the test frame to approximately level, ensuring even support.
CAUTION: Do not allow the isolator mount pads to slide on the floor while moving the tester.
They are not designed to accept side loading. Damage to the pads may result.
5. If applicable, connect the cables between the load frame and the control console.
6. Connect electrical power to the customer power terminal block. Proper grounding is a MUST.
NOTE: Follow all local and national codes, and be sure to use the correct voltage and amperage. Refer to
equipment data tag for the individual unit information.
CAUTION: Turn all power switches to OFF and place all controls in a neutral position before
supplying power to the machine.