4
OPERATING INSTRUCTIONS
1.
Hepa Dust bag installation:
a. Open the triangular shaped Hepa dust bag cover by gently pressing one end of
the locking bar to release the locking mechanism.
b. Grasp the cover in your hang, lifting the upper corners of the cover away from
the vacuum housing.
c. Slide the bottom edge of the cover away so the hinges on the cover slip out of
the housing.
d. Inside the dust bag cavity, a round foam filter helps to protect the motor. Be
sure this filter is in place prior to installation of the Hepa dust bag.
e. Gently unfold the new Hepa dust bag. The upper corner of the Hepa dust bag
should be slid in so they do not interfere with the cardboard plate resting
securely on the housing.
f. Ease the Hepa dust bag into the cavity, placing the cardboard plate onto the
exterior lip of the cavity, make sure that the cardboard plate is fitted behind the
two small clips on the exterior rim.
NOTE: The triangular shaped cardboard plate must be placed evenly on
the exterior rim of the housing for the dust bag cover to be properly
installed.
g. Then grasp the cover in your hand and insert the lower cover hinges into the
indentations. Be sure the Hepa dust bag cardboard plate is resting evenly on
the rim of the cavity. Close the cover and make certain it clicks into place.
e
f / g
