5
--Technical Specification
Model
CTD-3
CTD-3S
CTD-5
Rated Electric
115v, 60Hz, 1.5A
115v, 60Hz, 1.5A
115v, 60Hz, 1.7A
Refrigrant(Ounces)
R600a / 1.06
R600a / 1.16
R600a / 1.58
Design
Pressure(High/Low)
280 psig / 90 psig
280 psig / 90 psig
280 psig / 90 psig
Net weight(KG)
24
29
40
--Safe Cautions
1. This unit uses AC110V/60Hz power, there should be a 500va stabilizer if the voltage fluctuation
exceeds AC99V-132V
2. The user should hold the plug when the power is on /off, dragging or pulling the power cord is
prohibited.
3. Do not remove the power cord or plug
4. Must use dependent socket and reliable ground wire. Ground wire must not connect with the null
line of the gas pipe, warm gas pipe, water pipe and must be single power
5. Never splash water on the unit directly.
6. Keep away from explosive, hazardous goods such as ether, gas, alcohol, bonding agents, gunpowder
etc.
7. Keep away from spray of inflammables such as paints, coating materials etc.
8. After the unit is switched off, it should not be restarted within 5 minutes.
9. Do not leave the power cord under any heavy objects including the unit itself.
10. Do not drill holes or install other objects on the casing.
11. This cooler is not suitable for storage pharmaceutical products.
--Portage and storage
1. Keep the unit vertical when carrying the unit, the angle to the horizontal line should not be over
50
°,
otherwise it will damage the compressor and affect normal operation of the unit.
2.The unit should be place on a solid and firm ground, take away the bottom pack to lower the shock
and noise.
3.Leave at least 20 cm of distance between the back of the unit and the wall for ventilation and leave a
space with an open angle of 160
°
for the door.
4.Keep the unit away from heat sources and avoiding direct sunlight.
5. Never place the unit on a location where water can reach or with high moisture. Splashed water and
dirt should be wiped off in time by using a soft cloth.
6. Do not place the unit in the environment cold enough to be iced.
--Preparation
1.
Remove the carton and packing foam (including the bottom foam)before using.
2.
Clean the unit before using.
3.
Adjust the foot to make the unit steady according to the ground condition to lower the shock and
noise.
