3. Installation
Attach fiber cable from the media converter to the
fiber network. The fiber connections must be matched
between transmit socket and receive socket, the TX,
RX fiber cable must be paired at both ends.
Attach a UTP cable from the 10/100BASE-T network
to the RJ-45 port on the media converter.
Connect the power adapter to the media converter.
The Fiber-Link and T.P.-Link LEDs will light up when
all the cable connections are satisfactory.
4. LED Description
LED Status
Description
ON
Linked on fiber port
FLASH
Activity
Fiber-Link
OFF Not
linked
ON
Linked on UTP port
FLASH
Activity
T.P.-Link
OFF Not
linked
ON
Fiber port works in full duplex
mode
OFF
Fiber port works in half duplex
mode
Fiber-Duplex
FLASH
Half & collision happens
ON
UTP port works in full duplex
mode
OFF
UTP port works in half duplex
mode
T.P.-Duplex
FLASH
Half & collision happens
FLASH
Far end fault pattern received
Fiber-Fault
OFF
Far end fault pattern not
received
ON 100Base-TX
T.P.-100/10M
OFF 10Base-T
5. Technical Specifications
z
Standard Protocol: IEEE802.3 10Base-T
IEEE802.3u 100Base-TX/FX
z
Connector: 1 RJ-45 & 1 optical port ( SFP or 1X9)
z
Operation mode: full duplex or half duplex
z
Power supply: 5V DC 1A
z
Environmental
temperature:
0℃-60℃
z
Relative humidity: 5%-90%
z
UTP cable: Cat5 UTP cable
z
Fiber: 50/125um, 62.5/125um multi-mode fiber
or 9/125um single-mode fiber
z
Dimensions: 26mm x 71mm x 94mm
Cautions:
1. This product is suitable for indoor application.
2. Put on the dust cover of fiber interface when not used.
3. It is forbidden to stare at the TX fiber-transfer end with
naked eyes.
