Industrial Managed
Ethernet Switch – EH9711
User Manual
Page
56
of
223
Table 2.32 Descriptions of RMON Event
Label
Description
Factory
Default
Delete
Check to delete the entry. It will be deleted during the next save.
ID
Indicates the index of the entry. The range is from 1 to 65535.
Null
Desc
Indicates this event, the string length is from 0 to 127, default is a null string.
Null
Type
Indicates the notification of the event, the possible types are:
none
: No SNMP log is created, no SNMP trap is sent.
log
: Create SNMP log entry when the event is triggered.
snmptrap
: Send SNMP trap when the event is triggered.
logandtrap
: Create SNMP log entry and sent SNMP trap when the event is
triggered.
None
Event Last Time
Indicates the value of sysUpTime at the time this event entry last generated an
event.
0
2.5.2
Network
Under this
Security
Network
submenus, the users can configure network security for the EH9711 managed switch. Figure
2.51 shows list of menus under the
Security
Network
. Under this section, the users can setup security for port, network
access server (NAS), access control list (ACL), IP source guard, and ARP (Address Resolution Protocol) inspection.
Figure 2.51 Configuration-> Security -> Network
Menu
2.5.2.1
Port Security Configuration
Global and per-port security of the managed switch can be configured in this webpage as shown in Figure 2.52.
Port Security
allows for limiting the number of users on a given port. A user is identified by a MAC address and VLAN ID. If
Port Security
is enabled on a port, the limit specifies the maximum number of users on the port. If this number is exceeded, an action is taken
depending on violation mode. The violation mode can be one of the four different described below. The
Port Security
Configuration
on this page consists of two sections:
Global Configuration
and
Port Configuration
. Table 2.33 summarizes
the description of options for global and per-port configuration settings.
Please click on the
Save
button afterwards for a change to take effect, or click
Reset
button to undo any changes made locally
and revert to previously saved values.
