Industrial Managed
Ethernet Switch – EH9711
User Manual
Page
141
of
223
Click
Save
button to save the setting configuration. Click
Refresh
box to refresh the page immediately. Note that unsaved
changes will be lost.
2.17.2
Port config
The GVRP Port Config webpage shown in Figure 2.116 allows the user to enable or disable a port for GVRP operation. This
configuration can be performed either before or after GVRP is configured globally; however, the protocol operation will
remain the same. Table 2.104 describes the labels on GVRP Port Configuration.
Figure 2.116 Webpage to Configure Port for GVRP
Table 2.104 Descriptions of GVRP PortConfiguration
Label
Description
Factory
Default
Port
The logical port that is to be configured.
-
Mode
Mode can be either 'Disabled' or 'GVRP enabled'. These values turn the GVRP
feature off or on respectively for the port in question.
Disabled
Click
Save
button to save the setting configuration. Click
Reset
button to undo any changes made locally and revert to
previously saved values.
2.18
DDMI
Digital Diagnostics Monitoring Interface (DDMI) allows users to perform diagnostic tests on transceiver modules such as
small form-factor pluggable (SFP). Click Enabled this feature to view the various parameters of the transceiver module, such
as temperature, voltage, transmission power, and so on. Figure 2.117 shows the DDMI configuration webpage. Table 2.105
describes the option on DDMI Configuration webpage.
