30
Faults and self-help with troubleshooting
A58H / Swisscom EN / A31008-M2055-F151-1-2X19 / appendix.fm / 02.12.2008
Ve
rs
ion 4,
29
.10.
2007
Faults and self-help with
troubleshooting
Not every problem signifies a fault in your
telephone. In some cases, problems can
be resolved by briefly interrupting the
power supply to the base station (unplug
the power supply unit and then plug it in
again) or removing the battery cells from
the handset and reinserting them. The fol-
lowing information is designed to help
you with specific problems.
Important: Some problems or faults can
only be resolved if you take the complete
device (base station, handset and connec-
tion cable) to the place of purchase.
Approval
This device is intended for use within the
European Union and Switzerland. If used
in other countries, it must first be
approved nationally in the country in
question.
Country-specific requirements have been
taken into consideration.
If you have any questions about the diffe-
rences between the public phone net-
works, please contact your specialist dea-
ler or network provider.
Swisscom hereby declare that this device
meets the essential requirements and
other relevant regulations laid down in
Directive 1999/5/EC.
The Declaration of Conformity can be found on
the following website:
under the heading "Online Shop", Telephones,
Conformity Declaration.
The display is blank.
1. The handset is not switched on.
¥
Press
and hold
the end call key
a
.
2. The batteries are flat.
Charge or replace the batteries
"
Base
"
flashes in the display
.
1. The handset is outside the range of the
base station.
¥
Move the handset closer to the
base station.
2. The base station's range is reduced
because Eco Mode is activated (depending
on the base station, please see your
phone's user guide).
¥
Deactivate Eco Mode or reduce the dis-
tance between the handset and the
base station.
3. The base station is not turned on.
¥
Check the base station mains adapter.
Handset does not ring.
1. The ringer is deactivated.
¥
Activate the ringer (
The other party cannot hear you.
You have pressed the
§Mute§
display key.
The handset is "muted".
Activate the microphone again
You hear an error tone
(descending tone
sequence)
when inputting.
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user
guide if necessary.
