IMPORTANT NOTE:
Be careful not to strip these screws.
All H1 Screws must be tight - but not stripped.
Steel inserts
nuts must be
on bottom
PARTS REQUIRED
8 pcs -
H1
Phillips Flat Head Screw
2 pcs -
P3
Right Leg
2 pcs -
P11
Frame Bottom Board
8 pcs -
H4
Hex Head Bolt
2 pcs -
P4
Left Leg
1 pc -
T1
Wrench
8 pcs -
H5
Flat Washer
2 pcs -
P9
End Frame Panel
STEP 1:
Secure
P9
End Frame Panel to
P11
Frame Bottom Board using
H1
Screws as shown in
FIGURE 1A
.
Attach the assembly from
FIGURE 1A
to
P3
Right Leg and
P4
Left Leg by insert
H4
Bolts and
H5
Washers from inside of
leg as shown in
FIGURE 1B
. Use
T1
Wrench to tighten
H4
Bolts.
Repeat with other set of legs.
IMPORTANT NOTE: CAREFULLY LIFT UP THE AIR HOCKEY PLAYFIELD AND REMOVE ALL ASSEMBLY
PARTS, BEING SURE TO CHECK ALL INNER TABLE COMPARTMENTS FOR PARTS. FIND A CLEAN
LEVEL PLACE TO BEGIN ASSEMBLY. WE RECOMMEND BUILDING THE TABLE IN THE BOX TOP TO
PROTECT PARTS DURING ASSEMBLY.
FIGURE 1A
H1
P11
P9
FIGURE 1B
5
© 2013 Escalade Sports
For Customer Service Call 1-886-996-2729
All Right Reserved.
P4
P3
Grooves on this side.
H5
H4
H4
H5
Please note
Pre-Drilled
holes on
both
P9
&
P11
PARTS REQUIRED
10 pcs -
H2
Phillips Flat Head Screw
2 pcs -
P14
Leg Connecting Panel
2 pcs -
P15
Leg Panel Stiffener
STEP 2:
Install
P15
Leg Panel Stiffeners to
P14
Leg Connecting Panels using
H2
Screws as shown in
FIGURE 2
.
Important Note: Be careful not to strip these screws. All H2 Screws must be tight - but not stripped.
FIGURE 2
H2
P14
P15
Black laminate
on this side.
H2
H2
H2
H2
Please note
pilot holes on
this top.
Please note
Pre-Drilled
holes on
this side.