Atom Gasoline Powered Tiller User Manual Download Page 2

PARTS & CONTROLS

2

1,2. The 

handles 

of the Tiller are held by both hands.

  3.  The throttle interlock which releases the 

throttle trigger 

which increases speed of engine for automatic safety 

clutch to engage and thus rotate tines.

  4. 

RUN/STOP 

switch.

  5. 

Starter grip

 the grip of the pull starter which is the 

device to start the engine.

  6. 

Handle nut

 for holding handles onto housing.

  7. 

Depth adjustment

 for adjusting wheel to regulate tine 

depth.

  8. 

Tine cover 

reduces the risk of flying debris and direct 

contact with the feet or hands.

  9. 

Handle to lift Tiller

.

10. 

Tines 

rotate when engine speed is increased above 

idle.

11. 

Tine holdings nuts

 RH (shown) & LH thread on each 

end of tine shaft.

12. 

Wheel 

for moving and guiding tiller.

13. 

Cross Brace,

 attaches downward on handle.

14.  Left and right 

Handle Tubes

.

15. 

Fuel tank cap,

 for sealing the fuel tank filler.

20. 

Fuel pump primer

 provides additional fuel for a cold 

start.

21. 

Warning Label.

22.  Lift knob to remove cover.

 

Failure  to  obey  a  safety 

 

warning can result in injury  

 

to yourself and others.

!

WARNING

!

NOTE

 

Advises  you  of  information  or 

 

instructions vital to the operation 

 

or maintenance of the equipment.

 

THE  PURPOSE  OF  SAFETY  WARNING AND  NOTES  IN  THIS  MANUAL 

IS  TO ATTRACT YOUR ATTENTION  TO  POSSIBLE  DANGERS AND  THE 

EXPLANATIONS WITH THEM DESERVE YOUR CAREFUL ATTENTION AND

UNDERSTANDING. THE SAFETY WARNINGS IN THIS MANUAL AND ON THE TILLER DO NOT, BY THEMSELVES, 

ELIMINATE ANY DANGER. THE INSTRUCTIONS OR WARNINGS THEY GIVE ARE NOT SUBSTITUTES FOR PROPER 

ACCIDENT PREVENTION MEASURES.

!

SAFETY WARNING

INTRODUCTION – GAS TILLER

This Atom  Gasoline  Powered Tiller  is  designed  to 

the highest standards to ensure you many hours of 

uninterrupted service.
Pay special attention to the safety precautions outlined 

on pages 3 to 4. Only persons who understand this 

Manual are to operate the Tiller.
To  receive  maximum  performance  and  satisfaction 

from  your  Tiller,  it  is  important  that  you  read  and 

understand the maintenance and safety precautions 

before using the unit. Contact your Atom dealer or the 

Atom distributor in your area if you do not understand 

or cannot carry out any of the operating instructions 

in this Manual.
Atom’s  philosophy  is  to  continually  improve  all  of 

its  products. As  a  result,  engineering  changes  and 

improvements are made from time to time. Appearances 

may  differ  between  models.  This  manual  covers 

information required to operate, maintain and service our 

range of Garden Tillers as the principles of construction, 

use and service are similar.

CONTENTS

Parts and Controls ........................................................... 2

Safety Precautions ....................................................... 3-4

Assembling the Tiller ....................................................... 5

Fuel Mix and Fuelling ...................................................... 5

Starting and Stopping Instructions .................................. 6

Using Your Tiller ........................................................... 6-7

Troubleshooting ............................................................... 8

Tines Maintenance, Removal & Tightening ..................... 8

Lubrication of Gears ........................................................ 9

Air and Fuel Filter Maintenance ...................................... 9

Carburettor ...................................................................... 9

Adjusting Idle Speed ....................................................... 9

Lubrication of Gears ........................................................ 9

Spark Plug ..................................................................... 10

Remove Engine & Replace ........................................... 10

Remove Wheel and Replace Arm ................................. 10

Repair Trottle Trigger ..................................................... 10

Remove and Replace Clutch Drum ............................... 10

Repair to Main Body .......................................................11

Tiller Parts Illustration .................................................... 12

Tiller Parts List ............................................................... 13

Engine Parts  ................................................................. 14

Engine Parts Illustration ................................................ 14

Furrow Plow................................................................... 15

Warranty ........................................................................ 16

FIG 2

16. 

Fuel Tank.

17. 

Filter housing

 covers the air filter element.

18. 

Muffler 

reduces  exhaust  noises  and  drives 

gases away from operator.

19. 

Spark Plug terminal cap

 connects the spark 

plug to the ignition wire.

FURROW 

PLOW 

ATTACHMENT

See page 15

Summary of Contents for Gasoline Powered Tiller

















Reviews: