2
spEcIFIcATIons
magnification ............................................................. 4X
Fov............................................................................ 7.5°
range of focus ...........................................................10 m to infinity
reticle ........................................................................
red on Green
windage & elevation adjustments .............................
1/4moa
Ir illuminator .............................................................
Digital 450mw (
detachable
)
power Supply ................................................................. one 1.5v aa size battery
Battery life .................................................................. 30 hours
operating temperature .............................................
-40°C to +50°C
Storage temperature .................................................
-50°C to +70°C
Dimensions ................................................................
280x 103 x 93mm/11.0 x 4.1 x 3.7”
weight ........................................................................ 1.4kg/3.1 lb
Diopter adjustment .................................................... +6/-4
pREpARATIon FoR opERATIon
Before getting started make sure to follow these steps:
• Install the battery into its housing with the polarity order shown on the main body of the unit.
• Switch on the scope with the protective lens cover still
attached to the lens.
• Make sure that the green luminance of the light inten
-
sifier tube is present.
• Observe the scene, and adjust the diopter and/or lens
for optimal image clarity.
• You may now enter a dark environment or simply shut
the lights off in order to darken the room.
• Next, remove the lens cap/daylight filter.
• Finally, you may want to turn the infra red (IR) illuminator on. Notice the ability of the scope to
see in total darkness with the aid of the Ir illuminator.
opERATIng
mounTIng
1. Slightly loosen the fixing screws on the 7/8” weaver mount built into the scope.
2. place the scope on the weaver rail of the fire arm.
3. tighten the fixing screws.
NOTE:
Fixing screws may need to be tightened after continuous shooting.
mounTIng sysTEm
the atn night vision riflescopes mounting System allows to change the position of the rif-
lescope flexibly on the weapon in relation to a shooter in combination with the fixed positions
already available on the weaver rail. For this purpose in the base of the mounting bracket there
is a rail with a fixing projection. there are two grooves in the mounting bracket for mounting
this rail. Besides it is possible to change the position of the riflescope additionally by 1/3 of
inch. For doing this one needs to about-face the rail.
* atn reserves the right to change the above specifications at any time without notice
Battery
installation
