3
the smart series will let you know. Our MO-4 scope has a 3-button digital control panel that
allows the user to easily engage the main power, infra-red illuminator and the proximity sensor.
Color coded leds let you know the mode of operation you are using.
1. ON/OFF indicator light – when power is ON the led is green.
2. When the proximity sensor is activated the led will change to red.
3. When ir is ON the ir led is orange.
NOTE:
Only for MO-4 with 1st Gen. tube. You may notice a persistent green glow for up to five (5)
minutes after you have turned the unit off. This is normal for the 1st Gen. light intensifier tube.
fOcusINg
To focus the MO-4 first you will need to adjust the diopter. simply turn the diopter clockwise
until it stops. Then, while looking through the diopter at a subject, slowly turn the diopter back
counter clockwise until the grain in the image is sharp.
NOTE:
We suggest that you focus the diopter during daylight with the filter on.
Next. When you are in low-light conditions and the daylight filter is off, you may focus the front
lens to receive a sharp image, the diopter should not be adjusted.
NOTE:
The front lens should be readjusted as you view objects at different distances.
INfRA-RED IlluMINATION
infra-red illuminators, or ir illuminators, are common in night vision. The ir light greatly enhances
the performance of the MO-4 while remaining almost totally invisible to the naked eye. The ir
illuminator on the MO-4 is located to the side of the battery compartment.
To turn the ir on push the ir button and you will see an orange indicator light come on. it is
important to remember that the ir illuminator is simply an infra red light source, and like any
light source it may loose its effectiveness over a great distance.
you may desire a different field of coverage from the ir illuminator, if so, the beam is focusable.
By turning the lens of the ir illuminator you will slightly change the beam width.
NOTE:
The IR will automatically turn off when the unit’s main power switch is turned to the OFF
position.
lOw BATTERy INDIcATOR
The low battery indicator is another feature that is programmed into your “smart” scope. if
the batteries start losing voltage led “B” will start to pulse, it is time to change your batter-
ies.
cAMERA ADApTER
(OpTIONAl)
To use your MO-4 with a 35mm camera or camcorder you will need the following:
1) if you plan to use a camcorder then your camcorder must have a MaCrO feature. Most
modern camcorders today have a MaCrO feature built-in.
2) if you plan to use a 35mm camera you will need a MaCrO lens. if you don’t have one we
advise that you contact your local camera store.
3) you may or may not need a sTeP-uP or sTeP-dOWN ring in order to adapt the camera
adapter to your lens.
screw
Camera adapter
Joint ring
