9
REplAcINg DAY-VISIoN EYEpIEcE wITh NIghT-VISIoN oNE
Release the detent along arrow “Open”
on the sight body, turn it counter clock-
wise and take it out.
In order to install the night-vision sight
align the bayonet groove in the eye-
piece body with the pin (or finger) on
the interior surface of the sight body
(its location is marked with a dot on the
body), insert the eyepiece as far as it will go then turn it clockwise. Make sure that the
detent has operated and the eyepiece won’t rotate or get out. Replace the night-vision
with the day-vision one in a similar way.
ThE IR IllumINAToR
Infra-red (IR) Illuminators are common for
night vision technology. The IR light enhances
greatly the performance of your day/night
system (in night mode), while remaining
almost invisible to a naked eye. In a dark envi-
ronment, power up the day/night system (in
night mode) and observe a scene with the IR
off. Then observe the same scene with the
IR on. Note the difference in illumination. It is
important to remember that the IR illuminator
is an infra-red light source, and like any light source it may loose its effectiveness over a
great distance.
To fix the IR Illuminator to the riflescope screw the fixation screw on the IR into the thread
on the night-vision eyepiece body.
The IR illuminator control buttons are located on its side.
To switch the Digital IR illuminator on/off press “+” and “-” buttons simultaneously. When
the IR illuminator is switched on you can see the green LED lit.
By pushing the buttons “+” and “-” you may adjust the IR brightness.
The IR beam is focusable to change the field of coverage. To change the beam width
slightly turn the IR lens.
You may notice that beam of IR illuminator might not shine directly to the middle of your
viewing image. You can change the direction of the IR beam slightly in horizontal and
vertical directions with rotation of small screws on the side of IR.
You can also change the position of the IR control panel fit-
ting your needs. Unscrew the small set screw on back of IR.
Then use the included wrench to loosen back ring, Move the
IR to its desired position/angle, retighten ring with wrench then
retighten set screw.
Battery
Cap
IR Brightness
Adjustment
Battery
Housing
Fixation
Screw
IR Elevation
IR Windage
IR Focusing
