Atmos Multi Mk2, Manual, Page: 16 / 19

4. USER PROGRAM
The user program is identified by a permanently lit letter followed by a dot.
•
Access
: Press ‘Set’ button for approx. 5 seconds until the letter b. appears
•
Next setting
: Press ‘Set’ button
•
Different value
: Press ‘Hot water’ button
•
Exit program
: Press ‘Reset’ button
Code
Diagnostic
display Central heating
water display Function Setting
b. 0 1 Hot water tank temperature 60°C
0 2 *65°C
0 3 70°C
C. 8 8 Central heating temperature °C
0. 0 Central heating pressure sensor is not active
8. 8 Central heating pressure *BAR
F. 8 8 Serial last malfunction
G.
8 8 Serial last blocking
0.** 0 0 Weather-dependent regulation *Off
0 1 Room thermostat time
switch
0 2
S. 0 0 Non-standard setting (only applies to User program)
0 1 Return to standard* (only applies to User program)
* standard
**
only visible if outside temperature sensor is connected
5. INSTALLER PROGRAM
The Installer program is identified by a permanently illuminated letter without a dot.
•
Access
: Press ‘Set’ button for approx. 10 seconds until the letter A appears
•
Different value
: Press ‘Hot water’ button
•
Next setting
: Press ‘Set’ button
•
Exit program
: Press ‘Reset’ button
•
To sub-program
: Press ‘Set’ button followed by ‘Hot water’ button
Code
Diagnostic
display
Central heating
water display
Function Setting
A 8 8 Fictitious ionisation flow
L L Low capacity (continuous)
H H High capacity (continuous)
b 5 b To sub-mode sensor values
c 0 0
Modulate at central heating temperature Off
1 1 *On
C 6 0 Central heating water temperature (maximum) 60°C
7 5 75°C
9 0 *90°C
E 0 0
Three-way valve capacity control Off
1 1 *On
F 8 Malfunctions (maximum 15) Begin/end
8 8 - 8 = service identification number (0 - 6) Last malfunction code
8 8 - 8 = malfunction code Last malfunction code -1
8 8 etc.
G 8 Blocks (maximum 16) Begin/end
8 8 - 8 = service identification number (0 - 6) Last blocking code
8 8 - 8 = blocking code Last blocking code -1
8 8
etc.
* standard
ATMOS MULTI Mk2 version 2004 Appendix Page 16