Atmel Wireless LAN Access Point, User Manual

Page: 51 / 64

51
Enable SNMP Traps
Using this submenu you can either enable or disable SNMP traps, which are
messages displayed in the right bottom corner for the main window indicating
that an action related to the AP took place. Permitted messages are :
Trap Reassociation : This trap message is sent when a Station’s reassociation
request is received from the AP.
Trap Association: Indicates the reception of an association request packet and
the sender Station’s successful association with the Wireless AP.
Trap Disassociation : This trap message is sent when a disassociation
notification packet is received from a Station.
Trap Reset : This trap message is sent when the AP resets.
Trap Setting IP Address with Ping : This trap message is sent when the
Wireless AP IP address is set with the transmission of a ping message.
Trap Start Up : This trap message is sent when Wireless AP starts up.
Trap Failed to Erase Flash : This trap message is sent when Wireless AP fails
to erase flash.