Atmel STK200, Manual

Page: 33 / 40

STK200 Starter Kit 10-1
Section 10
In-System Programming
Devices can be programmed in your circuit rather than on the board using the STK200
ISP dongle that was included in the kit. The dongle works with a 0.1" pitch header that is
mounted on your application board.
You will need to use either a multiplexer chip (such as a 4053), or wire directly to the
pins of the device. The pins on the device are connected as follows:
In addition, the 5 Volts and Ground need to be connected to the programming
lead.
Do not exceed 5 volts or you may damage your computer. 4.75 to 5.25 volts is
allowed. This warning applies to any ISP system.
10.1 ISP Lead Layout
Note:
This is a face view of the ISP lead. Section 10.2 shows connector on user cir-
cuit.
AVR Device
1200 2313
2323/
2343 4414 8515
8535/
4434
MEGA603/
MEGA103
Pin
Reset Pin1 Pin1 Pin1 Pin9 Pin9 Pin9 Pin20
MOSI
(PDI)
PB5
Pin17
PB5
Pin17
PB0
Pin5
PB5
Pin6
PB5
Pin6
PB5
Pin6
PE0
Pin2
MISO
(PDO
PB6
Pin18
PB6
Pin18
PB1
Pin6
PB6
Pin7
PB6
Pin7
PB6
Pin7
PE1
Pin3
SCK
PB7
Pin19
PB7
Pin19
PB2
Pin7
PB7
Pin8
PB7
Pin8
PB7
Pin8
PB1
Pin11