Atmel SAM9X25, Manual

Page: 919 / 1145

919
11054A–ATARM–27-Jul-11
SAM9X25
919
11054A–ATARM–27-Jul-11
SAM9X25
Depending on the corresponding mask in the CAN_IMR register, an interrupt is generated while
WAKEUP is set. The SLEEP signal in the CAN_SR register is automatically cleared once
WAKEUP is set. WAKEUP signal is automatically cleared once SLEEP is set.
If no message is being sent on the bus, then the CAN controller is able to send a message
eleven bit times after disabling Low-power Mode.
If there is bus activity when Low-power mode is disabled, the CAN controller is synchronized
with the bus activity in the next interframe. The previous message is lost (see
Figure 41-9 ).
Figure 41-9. Disabling Low-power Mode
41.8 Functional Description
41.8.1 CAN Controller Initialization
After power-up reset, the CAN controller is disabled. The CAN controller clock must be activated
by the Power Management Controller (PMC) and the CAN controller interrupt line must be
enabled by the interrupt controller (AIC).
The CAN controller must be initialized with the CAN network parameters. The CAN_BR register
defines the sampling point in the bit time period. CAN_BR must be set before the CAN controller
is enabled by setting the CANEN field in the CAN_MR register.
The CAN controller is enabled by setting the CANEN flag in the CAN_MR register. At this stage,
the internal CAN controller state machine is reset, error counters are reset to 0, error flags are
reset to 0.
Once the CAN controller is enabled, bus synchronization is done automatically by scanning
eleven recessive bits. The WAKEUP bit in the CAN_SR register is automatically set to 1 when
the CAN controller is synchronized (WAKEUP and SLEEP are stuck at 0 after a reset).
The CAN controller can start listening to the network in Autobaud Mode. In this case, the error
counters are locked and a mailbox may be configured in Receive Mode. By scanning error flags,
the CAN_BR register values synchronized with the network. Once no error has been detected,
the application disables the Autobaud Mode, clearing the ABM field in the CAN_MR register.
SLEEP
(CAN_SR)
MRDY
(CAN_MSRx)
LPM
(CAN_MR)
CAN BUS
Bus Activity Detected
Message x
Interframe synchronization
WAKEUP
(CAN_SR)
Message lost