Atmel SAM9X25, Manual

Page: 828 / 1145

828
11054A–ATARM–27-Jul-11
SAM9X25
828
11054A–ATARM–27-Jul-11
SAM9X25
39.7.5.3 IrDA Demodulator
The demodulator is based on the IrDA Receive filter comprised of an 8-bit down counter which is
loaded with the value programmed in US_IF. When a falling edge is detected on the RXD pin,
the Filter Counter starts counting down at the Master Clock (MCK) speed. If a rising edge is
detected on the RXD pin, the counter stops and is reloaded with US_IF. If no rising edge is
detected when the counter reaches 0, the input of the receiver is driven low during one bit time.
Figure 39-34 illustrates the operations of the IrDA demodulator.
Figure 39-34. IrDA Demodulator Operations
As the IrDA mode uses the same logic as the ISO7816, note that the FI_DI_RATIO field in
US_FIDI must be set to a value higher than 0 in order to assure IrDA communications operate
correctly.
3 686 400 2 400 96 0.00% 78.13
20 000 000 2 400 521 0.03% 78.13
32 768 000 2 400 853 0.04% 78.13
Table 39-13. IrDA Baud Rate Error (Continued)
Peripheral Clock Baud Rate CD Baud Rate Error Pulse Time
MCK
RXD
Receiver
Input
Pulse
Rejected
6 5 4 3 2 6 1 6 5 4 3 2 0
Pulse
Accepted
Counter
Value