Atmel SAM9X25, Manual

Page: 809 / 1145

809
11054A–ATARM–27-Jul-11
SAM9X25
809
11054A–ATARM–27-Jul-11
SAM9X25
Figure 39-9. Preamble Patterns, Default Polarity Assumed
A start frame delimiter is to be configured using the ONEBIT field in the US_MR register. It con-
sists of a user-defined pattern that indicates the beginning of a valid data. Figure 39-10
illustrates these patterns. If the start frame delimiter, also known as start bit, is one bit, (ONEBIT
to 1), a logic zero is Manchester encoded and indicates that a new character is being sent seri-
ally on the line. If the start frame delimiter is a synchronization pattern also referred to as sync
(ONEBIT to 0), a sequence of 3 bit times is sent serially on the line to indicate the start of a new
character. The sync waveform is in itself an invalid Manchester waveform as the transition
occurs at the middle of the second bit time. Two distinct sync patterns are used: the command
sync and the data sync. The command sync has a logic one level for one and a half bit times,
then a transition to logic zero for the second one and a half bit times. If the MODSYNC field in
the US_MR register is set to 1, the next character is a command. If it is set to 0, the next charac-
ter is a data. When direct memory access is used, the MODSYNC field can be immediately
updated with a modified character located in memory. To enable this mode, VAR_SYNC field in
US_MR register must be set to 1. In this case, the MODSYNC field in US_MR is bypassed and
the sync configuration is held in the TXSYNH in the US_THR register. The USART character for-
mat is modified and includes sync information.
Manchester
encoded
data
Txd
SFD DATA
8 bit width "ALL_ONE" Preamble
Manchester
encoded
data
Txd
SFD
DATA
8 bit width "ALL_ZERO" Preamble
Manchester
encoded
data
Txd
SFD
DATA
8 bit width "ZERO_ONE" Preamble
Manchester
encoded
data
Txd
SFD
DATA
8 bit width "ONE_ZERO" Preamble