Atmel SAM9X25, Manual

Page: 389 / 1145

389
11054A–ATARM–27-Jul-11
SAM9X25
389
11054A–ATARM–27-Jul-11
SAM9X25
29.9.4 Write Mode
The WRITE_MODE parameter in the SMC_MODE register of the corresponding chip select indi-
cates which signal controls the write operation.
29.9.4.1 Write is Controlled by NWE (WRITE_MODE = 1):
Figure 29-14 shows the waveforms of a write operation with WRITE_MODE set to 1. The data is
put on the bus during the pulse and hold steps of the NWE signal. The internal data buffers are
turned out after the NWE_SETUP time, and until the end of the write cycle, regardless of the
programmed waveform on NCS.
Figure 29-14. WRITE_MODE = 1. The write operation is controlled by NWE
29.9.4.2 Write is Controlled by NCS (WRITE_MODE = 0)
Figure 29-15 shows the waveforms of a write operation with WRITE_MODE set to 0. The data is
put on the bus during the pulse and hold steps of the NCS signal. The internal data buffers are
turned out after the NCS_WR_SETUP time, and until the end of the write cycle, regardless of
the programmed waveform on NWE.
MCK
D[31:0]
NCS
A
[25:2]
NBS0, NBS1,
NBS2, NBS3,
A0, A1
NWE,
NWR0, NWR1,
NWR2, NWR3