6.
Appendix
6.1.
Getting Started with IAR
IAR Embedded Workbench
®
for ARM
®
is a proprietary high efficiency compiler not based on GCC.
Programming and debugging of Xplained Pro kits are supported in IAR
™
Embedded Workbench for ARM
using the common CMSIS-DAP interface. Some initial settings have to be set up in the project to get the
programming and debugging to work.
The following steps will explain how to get your project ready for programming and debugging:
1.
Make sure you have opened the project you want to configure. Open the
OPTIONS
dialog for the
project.
2.
In the category
General Options
, select the
Target
tab.
Select the device for the project or, if not
listed, the core of the device.
3.
In the category
Debugger
, select the
Setup
tab.
Select
CMSIS DAP
as the driver.
4.
In the category
Debugger
, select the
Download
tab.
Check the check box for
Use flash loader(s)
option.
5.
In the category
Debugger
>
CMSIS DAP
, select the
Setup
tab.
Select
System (default)
as the
reset method.
6.
In the category
Debugger
>
CMSIS DAP
, select the
JTAG/SWD
tab.
Select
SWD
as the interface
and optionally select the
SWD speed
.
Figure 6-1. Select Target Device
Atmel SAM4L8 Xplained Pro [USER GUIDE]
Atmel-42103B-SAM4L8-Xplained-Pro_User Guide-04/2016
24
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
