Atmel megaAVR, Getting Started

Page: 7 / 28

megaAVR™ Starter Kit Manual 3-1
Section 3
Connecting the System
A Power Supply is required with a standard 2.1mm barrel connector. It can be AC 7 -
12V or DC 9 - 15V. The connector is inserted into the power connection socket as
shown, above.
The programming lead supplied is fitted into the Dongle case and the other end is
inserted into the programming interface on the board as shown.
The Dongle case is connected to one of the printer ports on the PC. If this is not LPT1,
then you will need to change the printer port setting in the software—see software sec-
tion for details.
PLUG HEADER ON LEAD
INTO PROGRAMMING
INTERFACE - KEY WAY
GIVES ORIENTATION
CONNECT LEAD
SUPPLIED TO DONGLE
AND INSERT IN
PC PRINTER PORT
POWER SUPPLY
9 - 15V DC
7 - 12V AC
ON-OFF SWITCH
RS 232 CONNECTOR
NOT USED FOR
PROGRAMMING
POWER CONNECTOR
5.5/2.1 BARREL