AVR32913
3
32113-AVR32-07/08
More information about the different power inputs is available in the hardware user’s
guide.
When the board is powered the green LED, marked with “PWR”, will light up and the
default board firmware will start to run.
3 Preparing the board for audio playback
In order to play some music a USB mass-storage device must be connected to the
“USB USER” connector by using the “Mini-A plug to std-A receptacle” adaptor cable.
The adaptor cable is a kit content.
The default audio output should be configured to use the on board codec and thus the
jumpers on J6 should be set as indicated in the figure if not already set up like this.
Figure 3-1
Jumper settings on J6 for codec output to headphones
Connect a headphone or speaker to the jack in order to listen to the music.
4 Browsing the disk and playing music
After a mass-storage device has been connected to the USB-USER port the player
enters the disk browsing view. To control the application the touch sensors can be
used that are marked in the Figure 4-1.
