Preparing the ICE10 System for Use
2-2
AVR
®
ATICE10 User Guide
AVR Studio. Configuration of this device is controlled and done directly from AVR
Studio.
Figure 2-3.
ATtiny15POD
Figure 2-3 shows the ATtiny15POD which should be used when emulating the ATtiny15
device. The Pod provides a buffer protecting the emulator unit. In addition, the
ATtiny15POD contains a 4-channel 10-bit A/D converter with one differential input with
optional gain stage. This Pod is configured from AVR Studio, no manual jumper settings
are required.
Figure 2-4.
AT90ADCPOD
Figure 2-4 shows the AT90ADCPOD which should be used for a wide range of AVR
devices. This Pod must be configured manually with jumpers for correctly operation.
Configuration of the AT90ADCPOD is described in Section 4, and is also available as an
interactive configuration walkthrough in the on-line AVR Studio help system.
There are different Probe cables supplied with the ICE10 emulator. Only one pod, and
one probe cable should be used at any given time, and the pin count and shape of the
probe should match the device being emulated.
When using the ATtiny15POD only, the 8-pin DIP Probe can be used. When Using the
AT90ADCPOD, use the appropriate Probe for the device being emulated.
