AVR1908
3
8275A-AVR-04/10
AT90USB1287 device, and to power the QTouch Xplained & Xplain boards. Refer to
Figure 2-2 to see how to connect to the PC.
•
Connect an USB cable to the Xplain board and the host PC.
•
If programmed correctly (see section
Error! Reference source not found.
), the
board will register as a Human Interface Device (HID), so no driver installation is
required for most modern operating systems.
•
Launch QTouch Studio and wait for the Xplain board to register.
Figure 2-2
Connecting the QTouch Xplained & Xplain to the PC
3 Quick introduction to the QTouch Xplained features
The best way to learn how to use the QTouch Xplained is to go through the QTouch
Xplained training. This training is included in the zip file that is distributed with this
application note.
The QTouch Xplained consists of:
Figure 3-1
Slider
