Hardware Description
AT89EVK-01 User Guide
2-9
4325C–SCR–09/04
Figure 2-6. CEIBO “MP-51RD2 Programmer” Board and J1 connector
Figure 2-7. CEIBO “MP-51RD2 Programmer” Board and AT89EVK-01 connections
2.2.2
AT83C24 registers
programming
The Flash memory of the T89C5121 is loaded with FLIP/BatchISP if a new configuration
is needed for the AT83C24.
1.
Unzip the AT89EVK01_Vx.zip (x : version)
This zip file contains 3 files :
– AT83C24_batchisp.hex : T89C5121 firmware file
– at89evk01.bat : DOS command file
– AT83C24_batchisp_prog.txt : script file for batchisp software
2.
Copy all files at C:\Program Files\ATMEL\FLIP x.x.x\bin
3.
Connect the external waveform generator - Frequency at 14.74MHz or solder
SW4
4.
Connect the RS232C cable to PC serial port
5.
Connect power supply to the AT89EVK-01 board
6.
Switch on the power supply
7.
Execute at89evk01.bat
RS-232
AT89EVK01board
Rx(6)
Tx (4)
Vss(9)
Vcc (1)
J1
Vcc
Vss
Rx
Tx
1
9
4
6
5V Power Supply
Summary of Contents for AT89EVK-01
Page 2: ...Introduction 1 4 AT89EVK 01 User Guide 4325C SCR 09 04...
Page 10: ...Hardware Description 2 12 AT89EVK 01 User Guide 4325C SCR 09 04...
Page 13: ...AT89EVK 01 User Guide 4 15 4325C SCR 09 04 Section 4 Schematics...
Page 15: ...AT89EVK 01 User Guide 4 17 4325C SCR 09 04 Figure 4 3 Circuit Drawing...
