Atmel AT43DK355, User Manual, Page: 19 / 31

SEEPROM Loader
AT43DK355 USB Controller Dev. Kit User Guide 4-3
3429C–USB–7/04
3. Click on Write Flash button. Figure 4-4 will appear.
Figure 4-4. Selecting the File
4. Locate the *.hex file to be downloaded, and then click Open to start download-
ing. If successful, a message box will be displayed stating that the download was
a success. Select one of *.hex files which are located in the \USBWizard\Binary\
directory.
5. Once a successful upload has been completed, a message box will appear, as
shown in Figure 4-5.
6. Click OK to close the message box.
7. Disconnect the DB25 parallel cable from the J4 connector, then disconnect and
reconnect the board's USB upstream port to reset the evaluation board.
Another way to rest the board is to click on the Reset to make the board stay in a
Non-active reset state. And then, disconnect and reconnect the board's USB
upstream port.
Figure 4-5. A Successful Download
8. Clicking Exit will terminate the application.