Atmel AVR8015
9
32185A-AVR-01/12
9. Remove the squid cable between the programming headers.
Figure 4-6.
Sensor board connections.
10. Connect the touch panel.
11. For Atmel AT32UC3L: Use the QMatrix 8x8 Panel.
12. Launch Atmel QTouch Studio.
13. Plug the USB cable in to the Atmel QT600 interface board. Atmel QTouch Studio
should now automatically connect to the kit. Touch data LED on USB interface
board now starts blinking. This shows that data is being sent by the sensor board.
14. Select Analysis mode, and then press the Start Reading button.
You should now be able to view the touch data signals and the state of each sensor.
Refer the
.
Figure 4-7.
Virtual kit view.
In Analysis mode, sensors displayed in a light grey color are inactive, and the kit
will not respond to touches to these sensors. Sensors displayed in a light brown
color are active sensors, and the kit will respond to touches to these sensors.
Whenever a touch to an active sensor is detected, a green filled circle can be
seen indicating where the user touches the sensor.
