Atmark Techno Armadillo-210, Hardware Manual

Page: 10 / 22

Hardware Manual ver.1.0.1 Pre1
7
5. Interface Specifications
5.1. Layout of Interfaces
The layout of the Armadillo-210 interfaces is shown in Figure 5-1.
15
1
2
9
10
1 5
6 9
1 2
1 2
9
10
1 2
1 2
CON4
CON2
CON3
CON5
CON6
CON9
D2
D1
CON7 CON1
JP2
{
JP1
{
CON8
Figure 5-1 Layout of Interfaces
Table 5-1 Details of Interfaces
Symbol Interface Shape Remarks
CON1 LAN Connector (10BASE-T/100BASE-TX) RJ-45
CON2 Serial Interface 1 D-Sub9 pin (male)
CON3 Serial Interface 1 10-pin (2.54mm pitch)
Connector not mounted
CON4 Serial Interface 2 5-pin (2.54mm pitch)
Connector not mounted
CON5 Parallel Interface (8bit GPIO) 10-pin (2.54mm pitch)
Connector not mounted
CON6 External Reset/GPIO terminal 2-pin (2.54mm pitch)
Connector not mounted
CON7 Power Input Connector DC Jack
CON8 Power Input Terminal 2-pin (2.54mm pitch)
Connector not mounted
CON9 Power Output Terminal 2-pin (2.54mm pitch)
Connector not mounted
D1 Status LED (Green) LED
D2 Status LED (Red) LED
JP1 Jumper for Setting Boot Mode 2-pin (2.54mm pitch)
JP2 Jumper for Setting Boot Mode 2-pin (2.54mm pitch)