4
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515
RS-232 captive screw connector is included. RS-232 pin out will be determined by the RS-232 cable
and will connect as Rx
(receiver)
,
Tx
(transmitter)
,
and
(ground)
.
(See picture 1)
RS-232
Typical pin out:
2 - TX - Transmitter
3 - RX - Receiver
5 - GND - Ground
Pin out color will differ
per RS-232 cable.
1
5 4 3 2
9 8 7 6
1
RS-232
Ethernet
For convenience, the HDVS-200-TX-PSK comes with DHCP on. This enables the switcher to be
connected to a network without knowing available IP addresses. If your network is not compatible
with dynamic IP addresses or if you are using the switcher with a TCP/IP control system, DHCP may
be turned off and a static IP address set using RS-232 commands or the webGUI.
To disable DHCP, use the following command: IPDHCP off. Once disabled, set the IP address using
the IPStatic command (e.g. IPStatic 192.168.1.56).
webGUI
The HDVS-200-TX-PSK provides a built-in webGUI for easy setup and control.
To find the IP address of the switcher, connect the HDVS-200-TX-PSK to a terminal using an RS-
232 cable, and use the following settings: baud rate: 115200, data bits: 8, flow control: None,
stop bits: 1. Use the IPCFG command to display the IP address. Launch a web browser and enter
the IP address of the switcher.
A login screen will appear (this is the same log in for admin and general users). The login for the
webGUI will be username “root” and password “Atlona”.
