Installation Guide
5
AT-HDR-H2H-88MA
1. Connect up to 8 HDMI sources to the HDMI IN ports.
2. Connect up to 8 HDMI displays to the HDMI OUT ports.
3. For control, connect to the captive screw port for IR and RS-232, or the LAN port for TCP/
IP and webGUI.
4. Connect the included 24V power supply to the DC 24V port.
5. Connect the power supply to an AC outlet.
Installation
WebGUI
The AT-HDR-H2H-88MA includes a built-in webGUI, which allows easy management and control
of all features. Follow the instructions below to access the webGUI.
1. View the IP address of the unit using the front panel OSD.
•
Press the FNC button.
•
Press button 6 (INFO). The firmware version will display on the front panel screen.
•
Press button 6 again to bring up the IP address.
2. Launch a web browser and enter the IP address of the unit.
3. The AT-HDR-H2H-88MA
Login
page will be displayed.
4. Enter the following information on the
Login
page.
Login:
root
Password:
Atlona
5. Click the
Login
button.
NOTE:
If there is no IP address or the unit is not connected to a DHCP network, press
and hold buttons 1 + 2 for 5 seconds to switch the unit to a static IP address. The default
static IP address and netmask is 192.168.1.254 255.255.0.0.
AMS 2.0
For full configuration of the HDR-H2H-88MA, AMS 2.0 is available from https://atlona.com/AMS
for free. Two options can be used for installation: The free Linux based software download or the
easy to install server hardware (AT-AMS-HW).
Once AMS has been set up:
1. Open a browser on the same network as AMS 2.0 and go to the IP of AMS 2.0.
a.
View the AMS 2.0 installation instructions on how to find the IP of the software.
2. Enter the login information on the AMS 2.0 web page, then click the
Login
button.
3.
View the AT-HDR-H2H-88MA manual for routing and configuration.
