4
Step 1:
Place lower cross leg (C)
on ground, line up notches and
place upper cross leg (D) over
lower cross leg (C).
Step 3:
Fill each base (A & B) with sand and fasten cap (M). Place each base
section onto the cross legs as shown in diagram, lift support cap (L) for the
two inside base sections. When finished, slide the pole support cap down
to rest on top of the blow molded base.
Step 2:
Attach the umbrella frame (N) to cross
legs by using bolts (GG) and washers (HH)
found in blister pack. Lift the pole support
cap (L) up to align holes on bottom of umbrella
frame with holes on top of cross legs (C,D). Use
one washer and one bolt per hole, do not
overtighten. Adjust the umbrella frame to be
sure it is positioned correctly on base. Finally,
tighten bolts with adjustable wrench or open
end wrench (not included).
E
D
C
WARNING:
Before opening umbrella, complete assembly as instructed in manual. Fill each
water up to top. Cover hole with cap. It is recommended at least 150 kg (330 lbs) of weight be
placed on cross legs to ensure stability.Failure to do so will result in a weight imbalance and
cause umbrella to tip, causing damage and/or personal injury.
N
HH
GG
D
C
HH
GG
D
C
M
L
B
A
Assembly Instructions (cont.)
Minumum
150 kg / 330 lbs
Sand and Water
*Sand bags not included
B
A
22.75 kg
50lbs
22.75 kg
50lbs
22.75 kg
50lbs
22.75 kg
50lbs
22.75 kg
50lbs
Use 1 bag of sand in each
45.50 kg/100 lbs
2 bags
68.25 kg/150 lbs
3 bags
B piece, then add water up to top.
Use 1.5 bags of sand in each
A piece, then add water up to top.
