Atlas PA601, Owner'S Manual, Page: 7 / 16

Specifications are subject to change without notice
AtlasSound.com
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. • TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
©2006 ATLAS SOUND LP Printed in U.S.A. 00106 ATS002264 RevA 01/06 PP
OWNER'S MANUAL
PA601 COMMERCIAL AMPLIFIER
7
REAR PANEL DESCRIPTION
6. Balanced Input
Balanced line level signals connect to the (+), (–), and (G) terminals. Note if you are connecting an
unbalanced line level input, tie (short) the (G) and (–) terminals together with an insulated jumper
wire.
7. Line In
The Line In connector is useful for receiving a -6dBV mono unbalanced line level signal from a
playback system such as a CD player.
8. Line Out
Line Out connector is useful for providing unbalanced line level signal to another amplifier or other
external device.
9. Loudness Contour EQ
This switch, when in the ON position, pr4dB of boost at 100Hz and 8kHz. Use of this EQ is
suggested to enhance music playback at low levels.
10. Output Terminal Strip
For loudspeaker connections, connect as follows or proceed to the setup section for typical wiring
schemes.
COM - Speaker common or negative connection
4 Ω - Connect to direct coupled loudspeakers
70V - Connect to transformer coupled, 70.7V loudspeakers with a total load impedance of 83 Ω
100V - Connect to transformer coupled, 100V loudspeakers with a total load impedance of 167 Ω
11. IEC AC Receptacle
Prior to connecting a grounded power cord the proper selection of the AC Line switch and fuse must be
made. For 120VAC use the 1.6A/250V fuse and for 230~240VAC use the 1A250V fuse.
120V/230V-240V
1.5A/250V FOR 120V
0.8A/250V FOR 230V~240V
70V 100V 4
¡
COM
Speaker Output 60W
Line In
Line Out
Unbalanced
Loudness
On
Off
G – +
£Èä£Ê>VŽÊV>ÞÊ Û`°]ʘ˜ˆÃ]Ê/8ÊÇx££™Ê
­nää®ÊnÇȇÎÎÎÎÊ̏>Ã-œÕ˜`°Vœ“
F7,&'
7jbWiIekdZ7cfb_\_[h
Balanced
Line Input
CLASS 2 WIRING
FUSE
6 7 8 9 10 11