MECHANICAL COLD PANS
WCM/WCMD/WCMDC/WCML/WCMDL & WCMDCL SERIES
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------
INSTALLATION
Provide the correct counter cut-out opening (see chart below) and drop in. The vinyl gasket assures complete
seating. A non-toxic silicone seal may be used between the gasket and counter top (not required).
Note: Units are supplied with a nipple and stop valve to be connected for draining.
-------------------------------------------------------------------------------------------------------------------------------------------
The unit should be level for draining purposes. When installing unit in a counter, it is recommended that the
operator side of the counter be completely open for air circulation. When this is not possible, such as in an island
counter, it is recommended that two grill openings are provided approximately 18” x 18” of free air for intake and
exhaust at the opposite ends of the counter.
The unit is supplied with a power cord and NEMA plug. Refer to the data plate on the compressor housing for the
amperage and voltage information. Use a licensed electrician when installing power source.
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------
OPERATION
The unit is ready to operate as soon as it is plugged in. The thermostat has an off position and numbers from 1
through 7, (number 7 is the coldest). The unit should be turned off every day after use and turned on one hour before
serving.
----------------------------------------------------------------------------------------------------------------------------------------------------------------------
MAINTENANCE
NEVER
CLEAN PANS WITH A CHLORIDE BASED PRODUCT. CHLORIDES OR IMPROPER CLEANING
COULD SCAR, MARK AND/OR CORRODE PANS.
DO NOT
USE STEEL WOOL OR ABRASIVE
PRODUCTS. TO CLEAN USE SOAPY WARM WATER, RINSE THOROUGHLY TO REMOVE ALL
RESIDUES.
FAILURE TO MEET THESE
CONDITIONS WILL VOID WARRANTY
.
CLEAN CONDENSER COIL REGULARLY.
MODEL NUMBER
- CUT-OUT SIZE
WCM/ WCMD & WCMDC-1
22 1/4 X 14 1/4
WCM/ WCMD & WCMDC-2
22 1/4 X 28
WCM/ WCMD & WCMDC-3
22 1/4 X 41 3/4
WCM/ WCMD & WCMDC-4
22 1/4 X 55 1/2
WCM/ WCMD & WCMDC-5
22 1/4 X 69 1/4
WCM/ WCMD & WCMDC-6
22 1/4 X 83
WCML/ WCMDL & WCMDCL-2
14 1/4 X 44 1/4
WCML/ WCMDL & WCMDCL-3
14 1/4 X 66
WCML/ WCMDL & WCMDCL-4
14 1/4 X 87 3/4
