3/6
AtlasIED.com
TELEPHONE: (800) 876-3333
FAX (800) 765-3435
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
©20
15
Atlas S
ound L.P
. and Inno
vati
ve Electronic Designs, LLC.
All Rights R
eserved.
Atlas S
ound is a trademark of
Atlas S
ound L
.P. IED is a registered trademark of Inno
vati
ve Electronic Designs, LLC.
All other trademarks are the proper
ty of their respecti
ve owner
s.
All specs are subject to c
hange without notice.
ATS0
05347 R
evA 1
2/1
5
4. Attach the short speaker bracket to the wall bracket.
A. Position the short speaker bracket over the lower sliding mount block as shown in Fig. 3a.
B. Insert the 100mm M8 bolt through the short speaker bracket and the lower sliding mount block. Be sure to include the plain washers and one
lock washer as shown.
Note:
For angled installation, skip step 4C and proceed to step 4D.
C. If the speaker will be parallel to the wall, repeat steps 4A and 4B for the upper sliding mount block.
D. Position the medium speaker bracket over the upper sliding mount block as shown in Fig. 3b.
E. Insert the 100mm M8 bolt through the speaker bracket and the sliding mount block. Be sure to include the plain washers and one lock washer
as
shown.
5. Attach the speaker bracket to the wall bracket.
A. Insert the 20mm M8 bolt through the short speaker bracket, internal tooth lock washer, and the wall bracket as shown in Fig. 4a. Be sure to
include the plain washers and one split ring lock washer as shown.
B. Insert the 20mm M8 bolt through the medium speaker bracket and the upper wall bracket as shown in Fig.4b. Be sure to include the plain
washers and one split ring lock washer as shown.
C. Adjust horizontal position of the speaker and torque all bolts sufficiently to hold position.
Fig. 4a and 4b (Sliding Mount Block shown not attached to speaker for clarity)
Fig. 3a and 3b (Sliding Mount Block shown not attached to speaker for clarity)
