Owner’s Manual
TSD-DA13
1x3 Distribution Amplifier
AtlasIED.com
– 4 –
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
Rear Panel Description
TSD Input/Output connections are removable for easy system wiring. The connector has a 3.5mm
pitch between pins.
1.
DC Power Input
- Each TSD that requires DC power comes with a 2 position connector for
an external 24VDC power supply (sold separately). Because of the TSD’s low power consumption,
a single external power supply may power more than one TSD. Please refer to the specifications
on current requirements in milliamps to match with the appropriate power supply.
Note:
It is
acceptable to exceed the current requirements of the TSDs but NOT safe to use a power supply
that is below the current requirement of the device.
2.
Mic/Line Input
- Balanced Line level or balanced mic level signals are connected to this input.
Your source connects to a balanced line or mic level source. Your connection must be mated
properly to the input connector or signal loss and/or noise may occur. For gain or source input type
selection, refer to the “Dip Switch Function Identification” chart for proper input setting.
Note:
Unbalanced line level inputs can be inserted with proper wire configuration by connecting
the (G) and (-) terminals together.
3.
Mic/Line Output
- Balanced Line level signals provide output when an input signal is present
for connection to balanced mic or line level devices. Your output connections must be connected
properly to the connectors or loss and/or noise may be introduced into the signal.
Note:
Unbalanced line level devices can be used with proper wire configuration by connecting the
(G) and (-) terminals together.
4.
RCA Input
- Unbalanced audio signals applied to these female RCA connectors are electronically
summed and fed to the three outputs. It is NOT recommended to use the unbalanced RCA inputs
and the balanced input at the same time.
5.
Cable Management Retainer Points
- Each TSD includes two cable retainer straps for securing
the included cable management retainers. Remove one of the rear panel screws, align the
panel hole with a retainer and firmly tighten the screws.
4
1
2
3
5
5
5
5