Owner’s Manual
MWBPT
Wireless Belt Pack Transmitter
AtlasIED.com
– 5 –
Specifications are subject to change without notice.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800.876.3333 • Fax: 800.765.3435
Synchronizing Channels on the Receiver and Transmitter
Align infrared areas of the receiver and transmitter within 12" (30cm).
A. Changing the receiver’s channel
1. Press the synchronizing button on the belt pack (Fig 4).
2. The belt pack’s LED will illuminate, indicating the frequency is being transmitted to the receiver
and that the receiver is synchronizing channels with the belt pack (Fig 5).
B. Changing the belt pack’s channel
1. Press the synchronizing button on the receiver (Fig 6).
2. The receiver’s LED will illuminate, indicating the frequency is being transmitted to the belt pack
and that the belt pack is synchronizing channels with the receiver (Fig 7).
If this does not synchronize the channels, ensure the IR sensor panels are properly aligned and are
located within 12" (30cm) of each other and try synchronizing again.
Figure 3
< 12"
Figure 4
Figure 5
Figure 6
Figure 7
