Atmosphere
User Manual
AtlasIED.com
TELEPHONE: (800) 876-3333
1601 JACK MCKAY BLVD.
ENNIS, TEXAS 75119 U.S.A.
– 21 –
Audio Wall Plate Accessories
Audio Wall Plate Accessories that begin with an “A”, denoting that they are audio inputs, include:
A-XLR, A-RCA, and A-BT.
Note:
Only one audio input accessory can be connected to each bus-port (A-B - AZM4; A, B, C, D - AZM8). Once the
bus-port is connected to the AZM port with an audio input, the input associated with the bus-port will activate and allow settings to be entered.
The general settings DSP available is dependent on the type of wall plate that is connected. For example: For A-RCA and A-BT models, the
Phantom, High-pass Filter, Gate, De-Esser, and Compressor will not be active or available from the UI.
Audio Wall Plate Inputs
When an audio wall plate accessory is added to one of the 4 ports (AZM8 shown), the channel becomes active (lights up) and allows access
to settings and display activity.
1. The input stays faded until an audio wall plate accessory is present on the bus-port and detected by the AZM. This example UI shows that
no audio wall plate accessories are connected to Port B. Note: It can take up to 30 seconds for an audio wall plate to be detected and start
streaming audio.
2. Once connected, like Port A, C & D, the Port will light up and allow naming which will be added to the Inputs Selection list and populate all other
respective inputs where displayed, system wide.
3. This shows the dynamic processors activity indicators for the Gate, De-Esser, and Compressor are available, because there is a Microphone
input (A-XLR) connected to the D port, in this example.
4. Input Level adjust for Port A, “Lobby BT” allows fader adjustment to desired level or enter the dB level in window. When signal is present, fader
animates as a meter and shows: Green-signal activity, Red-clipping.
5. Mute – select to mute input channel.
6. This is the input settings link and opens the appropriate General Settings page for the type of input connected. I.e. An A-RCA wall plate
accessory will open the General Settings and DSP tabs for the RCA inputs. DSP tabs available follow the type of wall-plate connected to the
Port. In this example, Port D is an A-XLR with Microphone so it opens the following general settings for the A-XLR page:
A-XLR
Balanced Mic/
Line Input
A-RCA
Stereo Summed
dual RCA or
3.5mm TRS Input
A-BT
Bluetooth
Input
