7
Figure 13
Screws with
lock washers
Blade
support
plates
Blades
8. ATTACHING THE FAN
BLADES
Insert the blade through the slot in the
housing. Align the holes in the blade and the
fan motor assembly and secure with the
blade attachment screw (with lock washer)
and blade support plate.
Repeat this procedure with the remaining
blades.
Figure 12
Hanger
bracket
Canopy
Canopy cover
Screws
7. FINISHING THE
INSTALLATION
1. Slide the canopy up to hanger bracket and
place the key hole on the canopy over the
screw on the hanger bracket, turn canopy
until it locks in place at the narrow section of
the key holes. (Fig. 12)
2. Align the circular hole on canopy with the
remaining hole on the hanger bracket, secure
by tightening the two set screws.
Note:
Adjust the canopy screws as necessary until
the canopy and canopy cover are snug.
Warning:
Make sure tab at bottom of hanger
bracket is properly seated in groove of
hanger ball before attaching canopy to
bracket. Failure to properly seat tab in groove
could cause damage to electrical wiring.
