17
Fig. 9
Fig. 10
Fig. 12
Fig. 14
Fig. 15
STEP 3:
Lower the hex shaft until the mount/demount head (Fig. 9) rests next to the wheel and
on top of the tire. Then, lock the hex shaft in position, using the lock lever (Fig. 10,
11)
STEP 4:
Insert the lever between the tire bead and the front section of the mounting head (Fig. 12).
STEP 5:
Move the tire bead over the mounting head by pulling the lever over the
mount/demount head, and briefly pushing upward on the reverse pedal (Fig. 13).
NOTE: To avoid damaging the inner tube (if there is one), it is recommended to
perform step 7 with the inner tube valve stem positioned about 1” to the right of the
mounting head.
STEP 6:
With the lever (Fig. 13) held in position, rotate the turntable in a clockwise direction
by fully depressing the reverse pedal. Continue until the tire is completely separated
from the wheel.
STEP 7:
Remove the inner tube (if there is one), and repeat the above steps 6 through 9 for the
bottom side of the wheel / tire (See Fig. 14, 15).
Fig. 11
Fig. 13
