- 9 -
California Proposition 65
Spark arresters
IMPORTANT!
State and local safety codes specify that, in certain
locations, internal combustion engines that use
hydrocarbon fuels must be used with spark assesters.
A spark arrester is a device constructed of
nonflammable materials specifically for the purpose
of removing and retaining carbon and other
flammable particles from the exhaust flow of an
internal combustion engine.
Service safety
Before servicing
∞
Never perform even routine service (such as
changing oil and filters, or cleaning the engine)
unless all electrical components are shut down:
-
Ensure all light tower power circuits are shut
off.
-
Turn the engine key to OFF and set all circuit
breakers to the OFF position.
-
Disconnect cable from negative terminal on
battery.
∞
If the ground under or around the trailer is damp or
wet, move the trailer to a dry location and allow it
to dry before servicing. Do not allow water to
accumulate around the base of the light tower.
∞
Do not service the light tower if clothing or skin is
wet.
During servicing
∞
Keep hands, feet, and loose clothing away from
moving parts on engine and generator.
∞
Keep the light tower and all its components clean.
∞
Keep labels legible. Replace damaged or missing
labels. (Replacement labels are available from the
factory.)
∞
When hoisting or loading the trailer:
-
Ensure devices such as slings, chains, hooks,
ramps, and jacks are secure and will bear the
weight of the trailer. The trailer’s gross vehicle
weight rating (GVWR) is displayed on the
light tower vehicle identification tag.
-
Be aware and cautious of people’s proximity
to the trailer. Always ensure the safety of
nearby people.
CAUTION
Risk of severe burn.
-
Do not touch the engine,
exhaust pipes, or areas near
the exhaust at rear of trailer.
-
Do not remove radiator cap
when engine is hot.
Contents are hot and under
pressure.
DANGER
Health hazard.
The engine exhaust from this
product contains chemicals
known to the State of
California to cause cancer,
birth defects, or other
reproductive harm.
DANGER
High voltage.
Contact with live electrical
circuits will cause severe
injury or death.
- Turn off power before
servicing any component
on the light tower.
- Only a qualified electrician
should service the light
tower electrical system.
Summary of Contents for QLT M10
