Atlas Copco PNS 1250 Cud S3A/T3 APP, Instruction Manual

Page: 66 / 114

- 67 -
6.5 Engine consumable
specifications
6.5.1 Engine fuel specifications
For fuel specifications, please contact your Atlas
Copco Customer Center.
6.5.2 Engine oil specifications
High-quality, mineral, hydraulic or synthesized
hydrocarbon oil with rust and oxidation inhibitors,
anti-foam and anti-wear properties is recommended.
The viscosity grade should correspond to the ambient
temperature and ISO 3448, as follows.
Specifications PAROIL
PAROIL from Atlas Copco is the ONLY oil tested
and approved for use in all engines built into Atlas
Copco compressors and generators.
Extensive laboratory and field endurance tests on
Atlas Copco equipment have proven PAROIL to
match all lubrication demands in varied conditions. It
meets stringent quality control specifications to
ensure your equipment will run smoothly and
reliably.
The quality lubricant additives in PAROIL allow for
extended oil change intervals without any loss in
performance or longevity.
PAROIL provides wear protection under extreme
conditions. Powerful oxidation resistance, high
chemical stability and rust- inhibiting additives help
reduce corrosion, even within engines left idle for
extended periods.
PAROIL contains high quality anti-oxidants to
control deposits, sludge and contaminants that tend to
build up under very high temperatures.
PAROIL's detergent additives keep sludge forming
particles in a fine suspension instead of allowing them
to clog your filter and accumulate in the valve/rocker
cover area.
PAROIL releases excess heat efficiently, whilst
maintaining excellent bore-polish protection to limit
oil consumption.
PAROIL has an excellent Total Base Number (TBN)
retention and more alkalinity to control acid
formation.
PAROIL prevents Soot build-up.
PAROIL is optimized for the latest low emission
EURO -3 & -2, EPA TIER II, III & IV engines
running on low sulphur diesel for lower oil and fuel
consumption.
It is strongly recommended to use
Atlas Copco branded lubrication
oils for both compressor and engine.
Ambient temperature
range
Type of lubricant
between -10°C and 50°C
PAROIL E
Mission Green
!
Never mix synthetic with mineral
oil.
If you want to use another brand of
oil, consult Atlas Copco for more
information concerning the
recommended oil and service
intervals.
!