2920 1449 00
23
Instruction book
3 OPERATING INSTRUCTIONS
3.1Initial start-up
3.1.1 Safety precautions
The operator must apply all related safety precautions including
those mentioned in this book.
3.1.2 User manual
Read the "User manual for Elektronikon regulator for GA-GR-
ZA-ZE-ZR-ZT" to familiarize yourself with all regulator
functions.
3.1.3 Outdoor/altitude operation
If the compressor is installed outdoors or if the air inlet
temperature can be below 0°C, precautions must be taken. In
this case, and also if operating at high altitude, consult Atlas
Copco.
3.1.4 Moving/lifting
The compressor can be moved by a lift truck using the slots in
the frame. Make sure that the forks protrude from the other
side of the frame. The compressor can also be lifted after
inserting beams in the slots. Make sure that the beams cannot
slide and that they protrude from the frame equally. The chains
must be held parallel to the bodywork by chain spreaders in
order not to damage the compressor. The lifting equipment
must be placed in such a way that the compressor will be lifted
perpendicularly. Lift smoothly and avoid twisting.
3.1.5 Compressor control modes
Key switch (S5-Fig. 3.5) allows the operator to select four
control modes:
Key
Compressor control mode
position
10
Compressor off. The regulator will not react
to any start/stop or manual load/unload
command.
11
Local control mode (remote control mode
is made inactive):
The compressor can only be controlled by
the buttons on the control panel.
1
Bush (to be removed)
2
Vibration damper
Fig. 3.1 Transport fixations, gear casing
1
Bush (to be removed)
2
Vibration damper
Fig. 3.2 Transport fixations, drive motor
1
2
51440F
1
2
1
51441F
