ENG ENG
10
Thank You for choosing an Atlantis Product. For more detailed instructions on configuring and using the WebShare
144 WN+, please refer to the online manual on the CD.
1.1
Package Contents
Unpack the package and check all the items carefully. Also, keep the box and packing materials in case you need to
ship the unit in the future. The package should contain the following items: WebShare 144WN+, Power Adapter AC-
DC (12V, 1A), UTP cat. 5 cable (RJ-45 connector), Phone cable (RJ-11 connector), ADSL RJ11 Filter, Quick Start
Guide (English, Italian, French and Spanish), Cd-Rom contained manual(English and Italian), driver and utility,
Warranty Card.
If any item contained is damaged or missing, please contact your local dealer as soon as possible.
1.2
Factory Default Settings
Before you configure this WebShare Wireless N ADLS2+ Router, you need to know the following default settings:
Username:
admin
Password:
atlantis
IP address:
192.168.1.254
Subnet Mask:
255.255.255.0
WAN=
PPPoE, LLC/SNAP Bridging, VPI=8, VCI=35
ESSID=
A02-RA144-W300N+
, Channel=
6
, WEP/WPA=
WPA2-PSK (AES)
WPA Pre-shared Key:
WebSha
DHCP Server:
enable
(from
192.168.1.100
to
192.168.1.200
)
After the device has turned on, press it to reset the device or restore to factory
default settings. The operation is as below:
4 seconds or above:
restore to factory default settings (this is used when
you can not login to the router, e.g. forgot the password)
1.3
Cabling
First you must connect the product to the ADSL line through the RJ11 cable you have in equipment (in the port
DSL
),
then connect to the RJ45 ports the PCs of your Lan or others Switch. You can get to the Wireless Router through the
different client wireless compatible with the IEEE802.11b & IEEE802.11g/n standard. In the end connect the AC-DC
Adapter to the Wireless ADSL2+ Router and then to the socket. Once you’ve checked all the connections and you’ve
switched on the Wireless ADSL2+ Router the product will carry on immediately a autotest (60 seconds). Finished
this, the LEDs status will be the following:
LED
Status
PWR
Lit green
LAN 1-4
Lit or Blinking green if any device is connected to the Router
WLAN
Lit or Blinking green if any device is connected to the Router
WPS
OFF
USB
OFF
DSL
Lit green
INTERNET
OFF
The Led
ADSL
, if suitably connected, at first will be flashing and then it will remain fixed.
If the
ADSL Led
flashes periodically You have to force modulation. Click on
Advanced Setup,
then
DSL
. Choose
ADSL modulation
, then click on
Apply/Save.
One of the most common causes of problem is bad cabling or ADSL line(s). Make sure that all connected devices are
turned on. On the front panel of your router is a bank of LEDs. Verify that the LAN Link and ADSL line LEDs are lit. If
they are not, verify if you are using the proper cables. Make sure that all devices (e.g. telephones, fax machines,
analogue modems) connected to the same telephone line as your router have a line filter connected between them
and the wall outlet (unless you are using a Central Splitter or Central Filter installed by a qualified and licensed
