Any revisions must first be approved by the product designer. Version: 201710
Revision By: TD
13.
CRITICAL SEAL
Remove dust and dirt first. Seal the connection
between the glass receiver channel and the base
glazing channel
with clear
silicon, prior to
the installation
of panel
21 B.
14.
INSTALLATION OF
FIXED PANEL
Locate the glass
panel into the glazing
channel. Add or
remove packers in
the base glazing
channel as necessary.
15.
ADJUSTING
BLOCK
Apply the plastic
grommets into the
holes in the glass
panel
HZ-F.
Assemble retainer
plate as shown.
16.
SILL INFILL
Trim Sill Infill to suit. Apply a continuous bead of
clear silicon to each inside face of the base
channel. Ensure the ends of the Sill Infill are
sealed and place into the base channel in the
location as shown.
17.
FASTENING GLASS
Secure the glass panel into the receiver channel
by tightening hex screws firmly with hex key
supplied.
(Do not overtighten).
18.
ADJUSTING BLOCK COVERS
Apply clear silicon to the heads of the screws
and place the cover plate over the end retainer
plate. Tape in place for 24 hours.
19.
SILICON APPLICATION
Using the blue tape supplied, mask the glazing
channel and glass at the intersections as shown.
Apply clear silicon to the inside and outside of
the glass panel. Use the spatula provided to
remove provided to remove the excess silicon.
Remove the masking tape immediately after
application.
20.
BUMPER APPLICATION
Apply 15mm area of primer to wall tiles in
locations as shown by the dark dots. Place
bumpers onto
primer. Ensure
the door slides
to, and meets
the centre of the
bumpers.
Alternatively use
vertical seal
supplied.
