![background image](http://html1.mh-extra.com/html/atlantis/nanocom-ln/nanocom-ln_quick-installation-manual_3000489032.webp)
C O M E x p r e s s M o d u l e
N a n o C O M - L N
Appendix A Programming the Watchdog Timer
A-2
A.1 General Information
The NanoCOM-LN utilizes Fintek F75111 chipset as its watchdog timer
Controller.
The other Watchdog timer is set to second or minute and the range is 0
to 256 seconds or minutes.
When the timeout has occurred, that will generate a status bit to indicate
it and write one will be clear.
A.2 Access Interface
The F75111 provides one serial access interface, I2C Bus, to read/write
internal registers. The address of Serial Bus is
configurable by using power-on trapping of standby power VBS3V. The
pin 3 (GPIO13/I2C _ADDR) is multi-function pin. During the
VSB3V power-on, this pin serves as input detection of logic high or logic
low. This pin is default pull-down resistor with 100K ohms
mapping the Serial Bus address 0x9C (1001_1100). Another Serial Bus
address 0x6E (0110_1110) is set when external pull-up resistor with
10K ohms is connected in this pin.
Summary of Contents for NanoCOM-LN
