4
Any revisions must first be approved by the product designer. Version: 201909 Revision by: JST
9.
CRITICAL SEAL
Remove dust and dirt first. Seal the connection
between the glass receiver channel and the base
glazing channel with clear silicon prior to the
installation of panel
20 B.
Ensure the corner junction between wall
channel
and
base channel
is full of
silicon before
final glass
placement. It
is vital that all
junctions are
sealed
sufficiently.
Prior to installation of glass panels and infill. Use
the clear silicon supplied.
10.
INSTALLATION OF FIXED PANEL
Locate the glass panel
20MG-F
into the glazing
channel. Add or remove plastic packers (
BAG11
)
in the base
glazing
channel as
necessary.
This panel
must protrude
23mm above
the wall
channel.
11.
INSTALLATION OF THE RETURN PANEL.
Locate the glass panel
20 B
into the glazing
channel. Adjust height of panel if necessary by
adding or removing plastic packers (bag11) in
the base glazing channels.
12.
GLASS DOOR / TOP TRACK ASSEMBLY
Before proceeding check the length of the
supplied top track is correct. The top track
should fit between the wall and
20 B
glass return
panel and be the same measurement top and
bottom.
The next processes are easily achieved when the
door is laying flat on clean saw horses.
Alternatively use clean 50mm timber blocks on
the floor.
HANGER ASSEMBLY
The bolts on the
hangers must be
facing inside the
shower. Ensure the
direction of the door
is correct. Fit 2x
hangers to the door
(note clear gaskets fit
1x inside, 1x outside).
13.
SOFT CLOSE ASSEMBLY TO HANGER SET
Fit the idle roller and soft close mechanism to
the hangers using 4mm hex key. The red striker
must face upwards.
When the idle rollers are being fitted to hangers
apply a 5mm drop of clear silicone inside the
thread. This will ensure that the hanger does
not move out of adjustment.
